Why can stainless steel centrifugal fan bearing become hot? 

 The main material of the fan is iron shell fan, glass fiber reinforced plastic fan, stainless steel fan, etc. Although the material of the stainless steel fan is very good, the corrosion resistance is also very good. However, the temperature range of bearings is relatively low. Take bearings, for example. The highest temperature of the bearing cannot exceed 40 degrees Celsius. Once the temperature goes above this, it can have a big effect on the fan. Why can stainless steel centrifugal fan bearing become hot? Clean Windows and cooling pipes as needed to ensure the quality of chilled water and good heat dissipation. Bearing loading quality is poor, water heating reaction oil purification rate is too high, the temperature of chilled water is high. For window cleaning and cooling Pipe to ensure the quality of cooling water and cooling effect. Bearing quality is poor, hydrothermal reaction oil purification rate is high, freezing water temperature is high. Because stainless steel centrifugal fan gem wear is not lubricated, shaft deviation movement, bearing wear is very important, shaft and contact should be too large, why will stainless steel centrifugal fan bearing become hot? Form oil wedge, destroy the impact of oil body Sudden, cause organ fever. In addition, the pressure of repeated frozen water is high, the pressure of oil is high, and the bearing is heated. Pressure oil repeated sliding bearing smooth, tubing blocked, oil and alcohol, bearing heating, due to pump problems . Oil tracks collected so far, especially in summer, do not warrant measurements of repeated frozen water. Open the bearing assembly, check the oil ring and replace it immediately. In plain bearings, tank cars are often on the shaft and shaft foot Between being pulled back, but if the oil ring deforms and wears, the oil ring will be wrapped, thus reducing the oil overheating of the shaft and shaft.